Gas top-up
A gas top-up adds a small amount of refrigerant to an air conditioner that has lost some charge, while a full recharge evacuates and refills the whole system. Low refrigerant pressure, read in psi on the service gauges, usually means the system has a leak.
A gas top-up is the addition of refrigerant to an air conditioning system that is running low. The technician connects gauges to the service ports, reads the suction and discharge pressures in psi, and adds refrigerant until the reading falls within the range the unit's specifications call for. In Singapore, where most homes and offices run split-type units, this is the job most people mean when they ask for "aircon gas."
A top-up is different from a full recharge. A full recharge means recovering the remaining refrigerant, pulling a vacuum to remove air and moisture, and then charging the system to its rated weight. It is a larger job and is usually needed after a major repair, a compressor replacement, or when the system has been opened up and contaminated. A top-up assumes the system is basically sound and only needs a modest correction.
Pressure is the key measure. Refrigerant pressure is read in psi (pounds per square inch), and the correct figures depend on the refrigerant type and the outdoor temperature. A low reading on the suction side means the unit is short of refrigerant.
Refrigerant does not get used up in normal operation. A circuit is sealed, so if the pressure is low, gas has escaped somewhere. That is why a top-up is not a routine fix. If a unit needs gas every season, the underlying cause is a leak at a flare joint, valve, or pipe, and the leak should be located and repaired. Topping up without finding the leak only buys a few months before the pressure drops again.
If you need a technician for this work, you can browse providers in the aircon gas refill category.