Singapore Air Conditioning Repair Service Guide
Menu

PCB (control board)

A PCB (control board) is the printed circuit board inside an air conditioner that receives signals from the remote and sensors and switches the compressor, fan, and valves. When it fails, the unit may power on erratically, show error codes, or stop running altogether.

The PCB, or control board, is the printed circuit board inside the indoor and outdoor units of an air conditioner. It is the electronic brain of the system. It reads the temperature sensors, takes commands from the remote control or wall controller, and decides when to switch the compressor, fan motors, and expansion valve on or off. In most split-type units sold in Singapore, there is a board in the indoor unit and a separate one in the outdoor condenser unit, and the two talk to each other over a signal cable.

Why it matters: a board that fails can look like a dozen other problems. Because the board controls the whole sequence, a fault here can stop cooling even when the gas charge, filters, and coils are fine. Technicians usually have to rule out simpler causes first, such as a tripped isolator, a blocked filter, or a dirty condenser, before the board is suspected.

Common signs that point to the control board include the unit powering on and off at random, indicator lights flashing in a pattern that does not match the manual, the remote getting no response while the unit still has power, fan speeds that will not change, and a burnt smell or visible scorch marks on the board. Error codes shown on the display can come from the board or from a sensor or motor it is reading, so the code alone does not confirm the fault.

If you need someone to diagnose these symptoms, aircon repair troubleshooting providers are the right place to start in this directory.

"

Related on this site